SCI论文中如何描述XPS实验结果?
前言:
关于论文写作这一块,我们也有些日子没跟大家分享了,今天跟大家分享下XPS实验结果如何描述。还是那句话,不积跬步无以至千里。我们将一点一点地把这些内容总结出来分享给大家,希望对大家有所帮助。此前我们已经分享了一些关于XRD, SEM, TEM, BET实验结果描述的内容,详情请大家进入“科研资料”à”论文写作”分栏进行查看。
部分内容链接:
1. SCI论文中怎样描述XRD结果? Part 1. XRD谱图作为定性分析手段
2. SCI论文中怎样描述SEM结果? Part 1. 详细描述样品有着怎样的形貌
3. SCI论文中怎样描述TEM结果? Part 1. 详细描述样品有着怎样的形貌,由哪些微观结构组成。
4. 写作从点滴开始——SCI论文中如何描述物理吸脱附实验结果?
1. 如何非常详细地描述XPS实验结果?
举例: X-ray photoelectronspectroscopy (XPS) was used to characterize the Cu oxidation state. The coexistence of Cu(I) and Cu(II) in fresh 3K-Cu-20TiO2 catalyst is evidenced by a shoulder observed on the main peak at 931.6 eV (Figure 2a), which is assigned to Cu(I) species. The higher binding energy (BE) Cu 2p3/2 peak at 933.7 eV and its shakeup satellites are due to Cu(II). The Cu(I) percentage in fresh mesoporous 3K-Cu-20TiO2 is estimated to be 44%. For mesoporous 3K-Cu-50TiO2 , only Cu(I) species are confirmed by XPS. These Cu(I) species can be completely oxidized to Cu(II) by oxygen at 250 °C as evidenced by temperature programmed oxidation (TPO) and XPS data.
参考文献:Fan, J. et al., J. Am. Chem. Soc. 2009, 131, 15568 –15569.
提炼语言模板:
为什么做这个表征: X-ray photoelectronspectroscopy (XPS) was used to characterize the元素名称 oxidation state.
得到了哪些信息,说明了哪些问题:
定性分析结果:The coexistence of 元素化合态(I) and 元素化合态(II) in 样品名 catalyst is evidenced by a shoulder observed on the main peak at 峰位置 eV (Figure2a), which is assigned to 物种类型 species. The higher binding energy (BE) 峰属性 peak at峰位置eV and its shakeup satellites are due t o物种类型.
For 样品名, only物种类型species are confirmed by XPS.
定量分析结果:The 物种类型 percentage in样品名is estimated to be 百分比.
从这些信息可还可以进一步得到什么:These 物种类型 species can be completely ___ to物种类型 by 处理方法 as evidenced by 表征手段。
2.不同文章中描写XPS结果可能详略不一,下面总结一些比较常见的写法供大家参考。
备注:有关XPS的基础知识,大家可以进入科研资料-->基础知识分栏进行查看。相关内容:XPS谱图都包括些啥?
A. 主峰的定性分析(蓝色标记部分即为模板):
The In 3d spectrum exhibits two contributions, 3d5/2 and 3d3/2 (resulting from the spin–orbit splitting), located at respectively 444.7 and 452.2 eV(Figure a, bottom),which can be assigned to InP. The P 2p spectrum(Figure b, bottom) clearly evidences the presence of two chemical environments for phosphorus atoms. The spectrum has been fitted by considering two resolved doublets (with a spin–orbit splitting of ∼0.9 eV between 2p3/2 and 2p1/2). The first predominant doublet, present at 128.7–129.6 eV, is characteristic of InP. The second one, with a lower intensity, is located at higher binding energies, 133.2–134.1eV, and corresponds, in agreement with the NMR results, to phosphorus in an oxidized environment, probably InPOx.
参考文献:, H. et al. J. Am. Chem. Soc, 2012, 134, 19701-19708
B. 处理前后XPS主峰的变动
1. The shift in BEs when comparing the neat ZnO, CuO and the composite material () provides evidence of an interaction between the Cu2+ and Zn2+ species. Inclusion of La into the system shifted the Cu 2p3/2 peak maxima () from 933.4 eV at low La loadings (1 wt%) to 933.7 eV at higher La loadings (11 wt%) and was accompanied by a decrease in La 3d5/2 peak maxima () from 835.4 to 835.1 eV, demonstrating an interaction between CuO and La2O3. The simultaneous and opposing changes to Cu 2p and La 3d BEs infer a decrease in electron density in the Cu nucleus by increasing La dopant concentration. La2O3 inclusion had no influence on the ZnO peak maxima.
参考文献:Kam, R. et al., J. Catal. 2010, 273, 73-81.
2. Figure 5a summarizes the binding energy shifts measured with respect to Au-bulk (Au-4f7/2 = 84.0 eV) as a function of cluster size and support. An increase in the BE shift with decreasing cluster size has been observed for Au/SiO2/n-Si(001) in accordance with Chusuei et al. with a maximum shift of 0.88 eV at 1.5 nm.
参考文献:, B. J. Am. Chem. Soc., 2003, 125 (42), pp 12928–12934
C. XPS全谱的描述
Surface analysis of the films was carried out using X-rayphotoelectron spectroscopy (Figure 3). The Sb 3d5/2 and 3d3/2 peaks are observed at 529.7 and 537.3 eV,respectively. Additional peaks (525.9 and 535.4 eV) for Sb 3d indicate different chemical environments i.e., Sb−O and Sb−Te. The values of 539.6 eV(3d3/2) and 530.3 eV (3d5/2) are reported for antimony oxide in the literature. A broad peakfor Sb 3d3/2 is obtained due to overlapping with the O 1s (529.6 eV) peak. Thetwo Te 3d signals, corresponding to Te−Sb and Te−O, are also seen. The values for Te−O, i.e., 584 eV (3d3/2) and 574 eV (3d5/2), are comparable to literature values of 586 (3d3/2) and 576 eV (3d5/2).The presence of the O1s peak indicates that oxidation of the film takes place after exposure to the atmosphere.
参考文献:, S.J. Am. Chem. Soc., 2006, 128 (10), pp 3120–3121
D. 定量描述样品表面各元素含量
XPS revealed that N-doping occurred at a temperature as low as 300 °C for GO annealed in NH3, with∼3.2% N detected in the sample (Figures b, a). N levels in GO sheets annealed in NH3 between 300 and 1100 °C were in a range of ∼3−5%, with 500 °C annealingaffording the highest N-doping levelof∼5% (Figure a). Comparing the oxygen levels of GO samples annealed in NH3 andH2 at various temperatures, we found that the oxygen levels in GO annealed in NH3 were lower than in those annealed in H2 at the same temperatures except for 1100 °C (Figure b). This indicated more effective reduction effects of thermal annealing in NH3 than in H2 below∼1100 °C.
参考文献:Li, X. J.Am. Chem. Soc., 2009, 131 (43), pp 15939–15944
温馨提示:本文仅列出部分有代表性的写法,在阅读过程中如果碰到其他有代表性的,会补充到本文中。本文内容最终会归类到“科研资料”-->"论文写作"分栏,如果日后写作有需要,可以去公众号该分栏中进行查找。
研之成理面向所有感兴趣的朋友征集专栏作家,主要是一些专业软件和基础知识的分享。比如,Digital Micrograph, TIA, Photoshop, Image j, 红外分析软件,Chemoffice, Crystal Maker, Material studio等软件的使用;XRD结构精修,核磁,红外,程序升温实验,同步辐射,电化学基本标准手段等基础知识的分享。目前,由于小编人数有限,总结的周期会比较长,如果有更加专业的人来分担一部分的话,应该可以让大家更快更好地把基础知识这个方面落实好。欢迎愿意分享的朋友联系我,非常感谢。
如果感兴趣请联系邹同学(QQ:337472528)或者陈同学(QQ:708274),谢谢!我们也会帮助大家进行修改,和大家一起讨论怎样编排才是更好的方式,这也是一种学习成长的过程,不是么?
最后,真诚地希望大家能够在这个平台上展示自己,将自己的思想传递给更多的人。
注:研之成理是个纯公益平台,没有办法给到大家稿费,抱歉!如果真的有一天研之成理走上了商业化道路,那么所有的稿费我们也都会给大家补上。真诚真心,“研之成理”对人和对科研都是如此!
为方便研友们进行学术讨论,研之成理也开创了自己的QQ群,1号群:已满;2号群:536667802。欢迎大家加入进行激烈的学术讨论!
本文版权属于研之成理,转载请通过QQ联系我们,未经许可请勿盗版,谢谢!
长按下图识别图中二维码或者搜索微信号rationalscience,轻松关注我们,谢谢!